What Your Home Inspection Should CoverSiding: Look for dents or buckling Foundations: Look for cracks or water seepage Exterior Brick: Look for cracked bricks or mortar pulling away from bricks Insulation: Look for condition, adequate rating for climate (the higher the R value, the more effective the insulation is) Doors and Windows: Look for loose or tight fits, condition of locks, condition of weatherstripping Roof: Look for age, conditions of flashing, pooling water, buckled shingles, or loose gutters and downspouts Ceilings, walls, and moldings. Look for loose pieces, dry wall that is pulling away. Porch/Deck: Loose railings or step, rot Electrical: Look for condition of fuse box/circuit breakers, number of outlets in each room. Plumbing: Look for poor water pressure, banging pipes, rust spots or corrosion that indicate leaks, sufficient insulation Water Heater: Look for age, size adequate for house, speed of recovery, energy rating. Furnace/Air Conditioning: Look for age, energy rating. Furnaces are rated by annual fuel utilization efficiency; the higher the rating, the lower your fuel costs. However, other factors such as payback period and other operating costs, such as electricity to operate motors. Garage: Look for exterior in good repair; condition of floor—cracks, stains, etc.; condition of door mechanism. Basement: Look for water leakage, musty smell. Attic: Look for adequate ventilation, water leaks from roof. Septic Tanks (if applicable): Adequate absorption field capacity for the percolation rate in your area and the size of your family. Driveways/Sidewalks: Look for cracks, heaving pavement, crumbling near edges, stains. Reprinted from REALTOR® Magazine Online by permission of the NATIONAL ASSOCIATION OF REALTORS®. Copyright / All rights reserved. Courtesy of Bobby Kessinger, Realtor® https://www.bobbykessinger.com |